Tools And Test Equipment - McDATA 316095-B21 - StorageWorks Edge Switch 2/24 Installation And Service Manual

Tools and Test Equipment

• Beaconing to assist service personnel in locating a specific port or
switch. When port beaconing is enabled, the amber LED
associated with the port flashes. When unit beaconing is enabled,
the system error indicator on the front panel flashes. Beaconing
does not affect port or switch operation.
• An internal modem for use by support personnel to dial-in to the
management server (optional) for event notification and to
perform remote diagnostics.
• Automatic notification of significant system events (to support
personnel or administrators) through e-mail messages or the
call-home feature.
NOTE: The call-home feature is not available through the EFCM Basic
Edition. The call-home feature may not be available if the EFCM Lite
application is installed on a customer-supplied platform.
• SNMP management using the Fibre Channel Fabric Element MIB,
Transmission Control Protocol/Internet Protocol (TCP/IP) MIB-II
definition (RFC 1157), or a product-specific private enterprise
MIB that runs on the switch. Up to six authorized management
workstations can be configured through the EFCM Basic Edition
interface or Element Manager application to receive unsolicited
SNMP trap messages. The trap messages indicate product
operational state changes and failure conditions.
• Optional SNMP management using the Fibre Alliance MIB that
runs on the management server. Up to 12 authorized
management workstations can be configured through the SAN
management application to receive unsolicited SNMP trap
messages. The trap messages indicate operational state changes
and failure conditions.
This section describes tools and test equipment that may be required
to install, test, service, and verify operation of the product and
attached management server. These tools are supplied with the
product or must be supplied by service personnel.
General Information
General Information
1
1-13