Table of Contents
Advertisement
PROGRAMMING
CODE SETUP
The unit's Master Code is for owner/administrator level commands. The User Codes allow users to activate and
latch relays 1 and 2 and to transmit radio commands on channels one and two.
NOTE: The User Code cannot be the same as the Master Code.
ENTER A USER CODE NUMBERS
1. Enter the Master Code:
beep.
2. Enter the Program Code:
3. Enter New User Code:
4. Enter the Relay/Channel for the Code to control:
2
or no button is pressed.
NOTE: If no button is pressed in step 4, both
relays/channels will activate simultaneously.
CODE OPERATION
MASTER CODE OPERATIONS
TRIGGER RELAY 1 (ONLY)
Enter the Master Code:
NOTE: Requires Relay 2 be in Independent Mode.
ENABLE VACATION (LOCK DOWN) MODE
Locks the system from all User Code activity.
1. Enter the Master Code:
2. Enter the Program Code:
DISABLE VACATION (LOCK DOWN) MODE
1. Enter the Master Code:
2. Enter the Program Code:
TRIGGER RELAY 1 AND CHANNEL 1
1. Enter the Master Code:
2. Enter the Program Code:
TRIGGER RELAY 2 AND CHANNEL 2
1. Enter the Master Code:
2. Enter the Program Code:
USER CODE OPERATIONS
TRIGGER PROGRAMMED RELAY/CHANNEL FOR USER CODE
Enter the User Code:
will activate.
>> CODE SETUP AND CODE OPERATION
?
?
?
?
The unit will
9
The unit will beep.
?
?
?
?
?
?
?
?
5
2
?
?
?
?
5
3
?
?
?
?
1
?
?
?
?
2
?
?
?
?
The Relay/Channel
DELETE USER CODE NUMBERS
1. Enter the Master Code:
beep.
2. Enter the Program Code:
3. Enter User Code to be deleted:
1
or
ENTER A TEMPORARY (1 SHOT) USER CODE NUMBER
The TAC1 holds 1 temporary User Code.
1. Enter the Master Code:
2. Enter the Program Code:
3. Enter the Temporary User Code:
ENGAGE PARTY MODE (RELAY 1)
Party Mode will latch relay and trigger corresponding
channel.
1. Enter the Master Code:
2. Enter the Program Code:
To disengage party mode: Enter a valid code into the TAC1
keypad or enter "#9" into the local telephone.
ENGAGE PARTY MODE (RELAY 2)
Party Mode will latch relay and trigger corresponding
channel.
1. Enter the Master Code:
2. Enter the Program Code:
To disengage party mode: Enter a valid code into the TAC1
keypad or enter "#5" into the local telephone.
14
?
?
?
?
The unit will
The unit will beep.
7
?
?
?
?
The unit will beep.
5
1
?
?
?
?
5
4
?
?
?
?
5
6
Advertisement
Table of Contents
