Managing The Access Point List; Adding Access Points To The Managed List After Discovery - NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
• If more than one access point has the same IP address, then only one of them is
discovered at a time. (This is not applicable to access points in factory default state that
are in the same layer 2 network.) Add one access point to the managed list, change its IP
address, and then run discovery again to discover the next access point with the same IP
address.

Managing the Access Point List

Adding Access Points to the Managed List After Discovery

After the wireless controller auto discovers the access points as explained in
Discovery on page 46, add them so that the wireless controller can manage them.
1. On the last Discovery Wizard screen (Step 3 of X: Select Access Points to manage). You
can click an individual access point's check box to select it, or you can select the check box
on the upper left to select all access points.
2. Click Add. The access points are added to the Managed AP List, and the wireless
controller upgrades the firmware of the access points to the latest firmware that is
loaded on the wireless controller.
• If you want to wait until later to add the discovered access points, you can select
Access Point > Last Discovered to view the most recently discovered access
points. From this screen, you can add the access points to the Managed AP List.
• After you have added the access points to the Managed AP List, they are removed
from the discovery results and the Last Discovered screen.
3. Select Access Point > Managed AP List. The Managed AP List screen displays.
Figure 23.
Chapter 4: Access Point Discovery and Management
Access Point
| 50