Viewing The Network Summary Screen - NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual

Viewing the Network Summary Screen

Figure 83.
Table 36 explains the fields of the Network Status, Wireless Clients, and Rogue Access Points
tables on the Network Summary screen.
Table 36. Network Summary Screen Information
Setting
Network Status
For each wireless controller, access point, and client, the following information is displayed:
Up
Total
Down
Critical
Major
Alarms
Wireless Clients
For each wireless controller and wireless client, the following information is displayed:
Controller
Open
WEP
WPA
Description
The total number of managed devices that are running properly.
The total number of managed devices that cannot be pinged.
The wireless controller can ping these managed devices, but either cannot log in or
has detected that these device are different from the ones that were configured.
The number of managed devices for which the configuration differs from the one
that is set on the wireless controller. This situation occurs most likely because the
device runs outdated firmware or the wireless controller changed the configuration
while the device was down or offline.
The IP address of the wireless controller that manages the access points to which
the wireless clients are connected.
The number of wireless clients that are connected to managed access points using
security profiles configured with open mode.
The number of wireless clients that are connected to managed access points using
security profiles configured with WEP.
The number of wireless clients that are connected to managed access points using
security profiles configured with WPA.
Chapter 11: Monitoring the Wireless Network and Components | 125