NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual page 109

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
To enable and configure SNMP:
1. Select Maintenance > Remote Management > SNMP. The SNMP screen displays.
Figure 65.
2. Enable SNMP and configure the settings as explained in
Table 31. SNMP Settings
Setting
SNMP
Read-Only Community Name
Read-Write Community Name
Trap Community Name
IP Address to Receive Traps
Trap Port
SNMP Manager IP
3. Click Apply.
Description
Select this check box to enable SNMP for the wireless controller.
The community string that allows the SNMP manager to read the wireless
controller's MIB objects. The default setting is public.
The community string that allows the SNMP manager to read and write the
wireless controller's MIB objects. The default setting is private.
The community name that is associated with the IP address to receive
traps. The default setting is trap.
The IP address at which the SNMP manager receives traps sent from the
wireless controller.
The port on which the SNMP manager receives traps sent from the
wireless controller. The default setting is port 162.
The IP address of the SNMP manager. To allow any SNMP manager to
access the wireless controller, enter 255.255.255.255.
Chapter 9: Maintaining the Controller
Table 31.
| 109