Advanced Rf Management For Access Point Groups - NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Table 19. RF Management
Setting
Maximum Neighbors to Participate
in Self-healing
Self healing wait Time after AP
Failure
Periodic Coverage Hole Detection Select the Enable button if you would like the Coverage Hole Detection to
Alert Severity for Coverage Hole

Advanced RF Management for Access Point Groups

You can configure centralized RF management for access point groups in the Advanced RF
Management screen.
To configure advanced RF management:
1. Select Configuration > Wireless > Advanced > RF Management. The Advanced RF
Management screen displays:
Figure 44.
2. Configure the settings as explained in
3. Click Apply to save your settings.
Description
The maximum number of neighboring access points that increase or
decrease power to cover for a failing access point. Selecting 0 (zero)
disables this feature. Use close neighbors, not a distant access point, and
do not use all access points.
Number of minutes to validate, that is wait, before confirming a failed
access point and increasing transmit power to cover the area. Enter a value
greater than access point reboot time, which is usually a minute. This allows
for fluctuations in the power of nearby access points when access points are
rebooted.
run in the background periodically.
Specify what type of severity (Critical or Major) you would like to associate
with the Coverage Hole Detected event on the Logs & Alerts screen (see
Configuring Alarm Notification Settings on page 62.
Table 19, RF
Chapter 7: Configuring Wireless Settings
Management.
| 77