NETGEAR WC7520 - ProSafe 20-AP Wireless Controller Reference Manual page 52

ProSafe 20-AP Wireless Controller WC7520 Reference Manual
Figure 25.
4. Configure the settings as explained in
edited.
Table 7. Edit Access Point Settings
Setting
Access Point Info
Name
Model
Group
IP Settings
IP Address
Subnet Mask
Table
Description
A unique value that the indicates the access point name. By default, the name is
netgearxxxxxx, where xxxxxx represents the last six hexadecimal digits of access
points MAC address. You can change the name to one that is meaningful to you.
The model of the access point. This field is populated during the access point
discovery process.
The group to which the access point is assigned. This is a nonconfigurable field; the
group is always basic after the access point discovery process. However, you can
assign access points to groups on the WLAN Network screen. For more information,
see Managing Access Point Groups in the WLAN
The IP address of the access point. This field is populated during the access point
discovery process.
Note: You cannot use the wireless controller to change the access point's IP address.
The subnet mask of the access point. This is a nonconfigurable field; the information is
assigned during the access point discovery process.
Chapter 4: Access Point Discovery and Management
7. Some fields are masked out and cannot be
on page 66.
| 52