Unable To Send A Fax - Oki CX2731MFP Advance User Manual

Unable to Send a Fax

Symptom
Unable to send a
fax.
The MFP does
not continuously
scan a
document.
The MFP does
not send a fax
even though you
dialed the
number and
pressed <Mono
Start>.
Unable to
transmit a fax
manually.
The MFP does
not start
scanning (during
memory
transmission).
MC361/MC561/CX2731 MFP Advanced User's Guide
Point to check
Did you perform the
correct procedure?
Did you specify the
correct number?
Did you specify the
appropriate
command line?
Is it due to the
recipient MFP?
Did you load the
document correctly
on the ADF?
Did you load a
document other
than A4, letter or
legal 13/13.5/14 on
the ADF?
Did you specify the
appropriate
command line?
Did you load the
document correctly?
Did you dial the
correct number?
Is the recipient's
line busy?
Did you put down
the handset before
pressing <Mono
Start>?
Did you load the
document correctly?
Is there enough
memory?
284
– Issues: Fax Issues
Remedy
Check the appropriate
procedure and try again.
If you use speed dial, print the
speed dial list and check the
entry.
Specify the appropriate
command line for your region.
Contact the recipient and ask
him to check the MFP status.
Keep the leading edges of the
pages in the document even.
Only A4, letter, and legal 13/
13.5/14 size documents can be
sent from the ADF.
Specify the appropriate
command line for your region.
Load the document correctly.
Dial the correct number.
Wait until the line is open and
try again.
Press <Mono Start> first and
then put down the handset.
Load the document correctly.
Check the available memory.