Changing The Buzzer Volume - Oki CX2731MFP Advance User Manual

Note
• When the excess part is larger than the specified reduction
margin, the excess part is printed on the next page.
• When the excess part is smaller than the specified reduction
margin, the received image is reduced onto a single page.
• When you set [Rx Reduc. Rate] to [100%] and the excess part is
smaller than the specified reduction margin, the excess part is
discarded.

Changing the Buzzer Volume

To change the volume of the buzzer which sounds when there is an
incoming fax or call:
1 Press the <SETTING> key.
2 Press the down arrow key to select [Admin Setup], then press
<OK>.
3 Enter the administrator password.
4 Use the arrow keys to select [Enter], then press <OK>.
5 Press the down arrow key to select [Management], then press
<OK>.
6 Press the down arrow key to select [Sound Control], then press
<OK>.
7 Press the down arrow key to select [Buzzer Volume], then press
<OK>.
8 Press the down arrow key to select a volume, then press <OK>.
9 Use the left arrow key to go back to the main screen.
MC361/MC561/CX2731 MFP Advanced User's Guide
55
– Faxing: Fax Reception Settings