Removing and installing the support bracket
When working with some devices, such as hard disk drives, adapters, and memory
modules, you must first remove the support bracket to access the device.
Complete the following steps to remove the support bracket:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Remove the side cover (see "Removing the side cover" on page 10).
3. Pull out on the rear end of the support bracket at a 45° angle.
4. Disengage the front end of the support bracket from the server and set the
To reinstall the support bracket, reverse the previous steps.
Opening and closing the microprocessor air baffle
When working with some devices, such as microprocessors and memory modules,
you must first open the microprocessor air baffle to access the device.
Complete the following steps to open the microprocessor air baffle:
1. Read the safety information beginning on page v and "Installation guidelines" on
2. Remove the side cover (see "Removing the side cover" on page 10).
3. Remove the support bracket (see "Removing and installing the support
12
xSeries 226 Type 8648: Option Installation Guide
page 7.
bracket aside.
page 7.
bracket").