Table 24: Classification Fields For Example 2 - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Policy Management Configuration Guide
4.
5.
6.

Table 24: Classification Fields for Example 2

170
Creating and Attaching a Policy with IP Classifiers
Match all frames with UPC 1.
host1(config)#ip classifier-group upcCLACL user-packet-class 1 ip any any
Create a policy list.
host1(config)#ip policy-list ipPol
host1(config-policy-list)#classifier-group colorCLACL
host1(config-policy-list-classifier-group)#filter
host1(config-policy-list-classifier-group)#classifier-group ipFragCLACL
host1(config-policy-list-classifier-group)#filter
host1(config-policy-list-classifier-group)#classifier-group igmpCLACL
host1(config-policy-list-classifier-group)#forward
host1(config-policy-list-classifier-group)#classifier-group lowDelayCLACL
host1(config-policy-list-classifier-group)#traffic-class strict-priority
host1(config-policy-list-classifier-group)#classifier-group tcpCLACL
host1(config-policy-list-classifier-group)#forward
host1(config-policy-list-classifier-group)#classifier-group *
host1(config-policy-list-classifier-group)#filter
Apply the policy list to an interface.
host1(config)#interface atm 5/0/0.1
host1(config-if)#ip policy input ipPol
% too many classifier fields in policy
Table 24 on page 170 lists the active classifiers in the policy named ipPol and the
size of each classifier.
Classifiers
Source address
Source port
Destination port
Protocol
User packet class
Color
IP fragmentation
ToS
The configuration fails because the total value of the classifiers requested in the
ipPol policy is 136, which is greater than 128 bit CAM entry size limit.
Size (Bits)
32
16
16
8
8
8
8
8