Figure 18: Interface Stack For Hierarchical Policy Configuration - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

Junose software for broadband services routers policy management configuration guide
Table of Contents

Advertisement

Committed Action: transmit unconditional
Conformed Action: drop
Exceeded Action: drop
At I2 and I4:
Classified Video Flow. VIDEO_RATE, Committed Rate: 1 Mbps
Peak Rate: 0 Mbps
Committed Action: transmit unconditional
Conformed Action: drop
Exceeded Action: drop
All classified video flow policers over each PPP interface feed into a single policer
with the following configuration:
At I1 and I3:
All Flows. SESSION_RATE, Committed Rate: 3 Mbps
Peak Rate: 0 Mbps
Committed Action: transmit conditional
Conformed Action: drop
Exceeded Action: drop
At I2 and I4:
All Flows. SESSION_RATE, Committed Rate: 5Mbps
Peak Rate: 0 Mbps
Committed Action: transmit conditional
Conformed Action: drop
Exceeded Action: drop

Figure 18: Interface Stack for Hierarchical Policy Configuration

IPv4 I1
IPv6 I2
PPP 1
Create a hierarchical policy parameter list for PPP interfaces.
1.
Chapter 7: Creating Hierarchical Policies for Interface Groups
IPv4 I3
PPP 2
vlan
Example: PPP Interfaces Hierarchical Policy Configuration
IPv6 I4
155

Advertisement

Table of Contents
loading

This manual is also suitable for:

E series

Table of Contents