Related Topics
Setting the Committed Rate for a Rate-Limit Profile
You can set the committed rate as a percentage of a reference rate defined in the
specified policy parameter.
Related Topics
Setting the Conformed Action for a Rate-Limit Profile
You can use the conformed-action command. Packets are colored yellow.For IP and
IPv6 rate-limit profiles, mark the packet by setting the ToS byte (IP) or traffic class
field (IPv6) to the specified 8-bit value, and transmit the packet. The mark value is
masked with the default 255 unless it is overridden by the mask-val command to
specify a different mask; not supported on hierarchical rate limits. For MPLS rate-limit
profiles, set the EXP bits of MPLS packets to the specified value in the range 0–7,
and transmit the packet. The mark EXP value is masked with the default 7 unless
you use the exp-mask command to specify a different mask; not supported on
hierarchical rate limits. To set the conformed action for a rate-limit profile:
Related Topics
Setting the Exceeded Action for a Rate-Limit Profile
You can use the exceeded-action command to set the exceeded action for a rate-limit
profile: Packets are colored red. For IP and IPv6 rate-limit profiles, mark the packet
by setting the ToS byte (IP) or traffic class field (IPv6) to the specified 8-bit value,
and transmit the packet. The mark value is masked with the default 255 unless it is
overridden by the mask-val command to specify a different mask; not supported
on hierarchical rate limits. For MPLS rate-limit profiles, set the EXP bits of MPLS
packets to the specified value in the range 0–7, and transmit the packet.The mark
EXP value is masked with the default 7 unless you use the exp-mask command to
specify a different mask; not supported on hierarchical rate limits. The no version
restores the default value, drop.
committed-burst
Issue the committed-rate command from Rate Limit Profile Configuration mode
to set the committed rate in bits per second for a rate-limit profile:
host1(config-rate-limit-profile)#committed-rate refRlpRate percentage 10
committed-rate
Issue the conformed-action command from Rate Limit Profile Configuration
mode:
host1(config-rate-limit-profile)#conformed-action transmit
conformed-action
Chapter 5: Creating Rate-Limit Profiles
Setting the Committed Rate for a Rate-Limit Profile
91