Chapter 2 Creating Classifier Control Lists For Policies - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

Table 3: CLACL Criteria (continued)
Type of CLACL Criteria
IPv6 Color
Destination IPv6 address
Destination port
Destination route class
Internet Control Message Protocol version 6 (ICMPv6)
IPv6 traffic class
Locally destined traffic
Multicast Listener Discovery (MLD)
Next header
Source IPv6 address
Source port
Source route class
Traffic class
Transmission Control Protocol (TCP)
User Datagram Protocol (UDP)
User packet class
L2TP Color
Traffic class
User packet class
MPLS Color
Mark experimental (EXP) bit
Traffic class
User packet class
VLAN Color
Traffic class
User packet class
User priority
You configure CLACLs with a name and then values to match in the IP datagram
header. A CLACL does not include an action: actions take place when a match is
included in a policy list.
NOTE: Do not use the asterisk (*) for the name of a classifier list. The asterisk is used
as a wildcard for the classifier-group command.
If you do not specify one of the frame-relay, gre-tunnel, ip, ipv6, l2tp, mpls, or
vlan keywords, the router creates an IP classifier list. This version of the command
has been deprecated and may be removed in a future release.
Chapter 2: Creating Classifier Control Lists for Policies
Classifier Control Lists Overview
9