Table 7: Ascend-Data-Filter Attribute Values For A Radius Record - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

In this example, the following Ascend-Data-Filter attribute creates a RADIUS record
that configures an input policy on an IPv4 interface. The policy filters TCP packets
from host address 10.2.1.2 to any destination. The policy marks the packets with a
ToS byte of 5 and a mask of 170. The policy also applies a traffic class named someTcl
and a rate-limit profile named someRlp.
Table 7 on page 55 lists the values specified in the Ascend-Data-Filter attribute.

Table 7: Ascend-Data-Filter Attribute Values for a RADIUS Record

Action or Classifier
Type
Forward
Indirection
Spare
Source IP address
Destination IP address
Source IP mask
Destination IP mask
Protocol
Established
Source port
Destination port
Source port qualifier
Destination port qualifier
Reserved
Marking value
Marking mask
Traffic class
Rate-limit profile
host1#show classifier-list
Ascend-Data-Filter="01010100 0a020102 00000000 20000600 045708ae
02010000 05aa0773 6f6d6554 636c0773 6f6d6552 6c70"
Hex Value
01
01
01
00
0a020102
00000000
20
00
06
00
0000
0000
00
00
0000
05
aa
0773 6f6d6554 636c
0773 6f6d6552 6c70
Examples: Using the Ascend-Data-Filter Attribute for IPv4 Subscribers
Chapter 4: Creating Classifier Groups and Policy Rules
Actual Value
IPv4
Filter
Ingress
None
10.2.1.2
Any
32 (0.0.0.0)
0 (255,255,255,255)
TCP
None
None
None
None
None
None
5
170
someTcl
someRlp
55