Configure Wpa/Wpa2 Personal - D-Link DIR-505 User Manual

Section 3 - Configuration
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the
added overhead.
1. Log into the web-based configuration by opening a web
browser and entering the IP address of the access point
(192.168.0.50). Click on Setup and then click Wireless Settings
on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to Cipher Type, select TKIP, AES, or Auto.
4. Next to Passphrase, enter a key. The key is entered as a
passphrase in ASCII format at both ends of the wireless
connection. The passphrase must be between 8-63 characters.
6. Click Save. Settings at the top of the window to save your
settings. If you are configuring the access point with a wireless
adapter, you will lose connectivity until you enable WPA-PSK
on your adapter and enter the same passphrase as you did on
the access point.
D-Link DIR-505 User Manual

Configure WPA/WPA2 Personal

110