Setup; Wireless Setup - D-Link DIR-505 User Manual

Section 3 - Configuration
Enable Wireless:
Check the box to enable the wireless function. If you do not want to use
wireless, uncheck the box to disable all the wireless functions.
Wireless Network
Service Set Identifier (SSID) is the name of your wireless network.
Name:
Create a name using up to 32 characters. The SSID is case-sensitive.
Wireless Mode:
Select one of the following:
802.11g.Only - Select if all of your wireless clients are 802.11g.
802.11n.Only - Select only if all of your wireless clients are 802.11n.
Mixed.802.11n.and.802.11g - Select if you are using a mix of 802.11n
and 11g wireless clients.
Enable Auto Channel
The Auto.Channel.Scan setting can be selected to allow the DIR-657 to
Scan:
choose the channel with the least amount of interference.
Wireless Channel:
Indicates the channel setting for the DIR-657. By default the channel is
set to 6. The Channel can be changed to fit the channel setting for an
existing wireless network or to customize the wireless network. If you
enable Auto.Channel.Scan, this option will be greyed out.
Channel Width:
Select the Channel Width:
Auto.20/40 - This is the default setting. Select if you are
using both 802.11n and non-802.11n wireless devices.
20MHz - Select if you are not using any 802.11n wireless clients.
40MHz - Select if using only 802.11n wireless clients.
Visibility Status:
Select Invisible if you do not want the SSID of your wireless network to
be broadcasted by the DIR-657. If Invisible is selected, the SSID of the
DIR-657 will not be seen by Site Survey utilities so your wireless clients
will have to know the SSID of your DIR-657
D-Link DIR-505 User Manual

Setup

Wireless Setup

83