Setting Up Iprint On The Oes 2 Linux Iprint Cluster Resource; Setting Up Preferred Nodes For The Oes 2 Linux Iprint Cluster Resource; Editing The Load And Unload Scripts For The Oes 2 Linux Iprint Cluster Resource - Novell OPEN ENTERPRISE SERVER - CONVERSION GUIDE 12-2010 Manual

13.2.2 Setting Up iPrint on the OES 2 Linux iPrint Cluster
Resource
1 In iManager, select iPrint > Create Driver Store, then create a Driver Store on the OES 2 Linux
node where the iPrint cluster resource is active.
For information, see
Administration Guide.
Use the IP or DNS name of the shared NSS pool resource that you created in
"Preparing the OES 2 Linux Nodes for iPrint," on page 55
eDirectory Server Name, choose an eDirectory server that holds a copy of the replica where the
Printer Agents will be created.
2 In iManager, select iPrint > Create Print Manager, then create a Print Manager on the OES 2
Linux node where the iPrint cluster resource is active.
For information, see
Administration Guide.
Use the IP or DNS name of the shared NSS pool resource that you created in
"Preparing the OES 2 Linux Nodes for iPrint," on page 55
eDirectory Server Name, choose same server that you specified for the Driver Store. Deselect
the Start print manager after creation option.
13.2.3 Setting Up Preferred Nodes for the OES 2 Linux iPrint
Cluster Resource
Configure the Preferred Nodes list for the Linux shared NSS pool cluster resource to prevent an
inadvertent failback of the resource to a NetWare server.
1 In iManager, click Clusters > Cluster Manager, then select the cluster where the Linux shared
NSS pool resource is currently active.
2 Select the link for the OES 2 Linux shared NSS pool cluster resource to open its Properties
page.
3 Go to the Preferred Nodes tab.
4 Move all of the NetWare nodes from the Assigned Nodes list to Unassigned Nodes list.
5 Click OK to save your changes.
13.2.4 Editing the Load and Unload Scripts for the OES 2 Linux
iPrint Cluster Resource
Edit the load and unload scripts for the OES 2 Linux iPrint cluster resource.
1 Edit the load script. Add the following lines to the existing load script before the
statement
ignore_error mv /media/nss/NSSVOL1/var/opt/novell/iprint/iprintgw.lpr /
media/nss/NSSVOL1/var/opt/novell/iprint/iprintgw.lpr.bak
NOTE: Replace
/media/nss/NSSVOL1
volume mount point.
"Creating a Driver Store" in the
"Creating a Print Manager" in the
in the above command with your actual cluster
OES 2 SP3: iPrint for Linux
Section 13.2.1,
as the Target Server. For the
OES 2 SP3: iPrint for Linux
Section 13.2.1,
as the iPrint Service. For the
exit 0
Novell iPrint 57