Table of Contents
Advertisement
AGENT CLUSTERING WORKSHEET
Under
Item 2: Domain Failover
list. The MTA might need to run on any node that the domain partition fails over to. Therefore, you will
install the agent software on all of the nodes in the domain failover list.
If you are planning the post office on a different GroupWise partition from where the domain is located,
under
Item 5: Post Office Failover
failover list. The POA might need to run on any node that the post office partition fails over to. Therefore,
you will install the agent software on all of the nodes in the post office failover list.
13.6.3 Determining Cluster Resource Information for the Linux
Agents
A cluster resource is a
shared
that can function successfully anywhere in the cluster. Cluster resources include the GroupWise
agents and the Messenger agents. When using the Configure GroupWise for Clustering option, the
GroupWise Installation program needs to know the mount point for the
it will create the domain and post office. For example, you might create a
point, or you might create
needs to know the secondary IP address of the GroupWise partition.
AGENT CLUSTERING WORKSHEET
Under
Item 7: Cluster Resource
GroupWise partition where the domain and post office will be located.
13.6.4 Planning the Linux Agent Installation
Aside from the cluster-specific issues discussed in the preceding sections, the considerations
involved in planning to install the GroupWise Linux agents are the same in a clustering environment
as for any other environment. Review
"GroupWise Agent Installation Summary
GroupWise 8 Installation Guide
POA.
IMPORTANT: Do not install the Linux agent software until you are instructed to do so in
Chapter 14, "Setting Up a Domain and a Post Office in a Linux Cluster," on page
Skip to
Chapter 14, "Setting Up a Domain and a Post Office in a Linux Cluster," on page
13.7 GroupWise Clustering Worksheets
Section 13.7.1, "System Clustering Worksheet," on page 134
Section 13.7.2, "Agent Clustering Worksheet," on page 135
List, list the nodes that you want to have in the domain partition failover
List, list the nodes that you want to have in the post office partition
partition, secondary IP address, application, service, Web server, etc.,
and
/mnt/dom1
/mnt/po1
Information, list the mount point and secondary IP address for the
"Planning the GroupWise
Sheet" in
for each location where you will install the Linux MTA and/or
GroupWise partition
/mnt/gwsystem
mount points. The Installation program also
Agents", then print and fill out the
"Installing GroupWise
Agents" in the
Planning GroupWise in a Linux Cluster 133
where
mount
137.
137.
Advertisement
Table of Contents
