Novell OPEN ENTERPRISE SERVER - CONVERSION GUIDE 12-2010 Manual page 29

9e Continue through the installation process until you reach the Novell Open Enterprise
Server Configuration page.
9f Reconfigure LDAP Configuration of Open Enterprise Services to specify the credentials
for the container administrator user (or non-administrator user) who has the eDirectory
rights needed to install Novell Cluster Services.
For information about what rights are needed, see
Administrators (or Non-Administrator
1.8.8 Administration Guide for
9f1 On the Novell Open Enterprise Server Configuration page under LDAP
Configuration of Open Enterprise Services, click the disabled link to enable re-
configuration.
The sentence changes to Reconfiguration is enabled.
9f2 Click the LDAP Configuration of Open Enterprise Services link to open the LDAP
Configuration page.
9f3 Specify the following values:

Admin name and context: The username and context (in LDAP form) of the
container administrator user (or non-administrator user) who has the eDirectory
rights needed to install Novell Cluster Services.

Admin password: The password of the container administrator (or non-
administrator user).
9f4 Click Next.
The install returns to the Novell Open Enterprise Server Configuration page.
9g On the Novell Open Enterprise Server Configuration page under Novell Cluster Services,
click the disabled link to enable configuration.
The sentence changes to Configuration is enabled.
9h Click the Novell Cluster Services link to open the Novell Cluster Services Configuration
page.
9i Click Existing Cluster, specify the fully distinguished name (FDN) of the cluster, then
click Next.
IMPORTANT: Use the comma format illustrated in the example. Do not use dots.
This is the name and eDirectory context of the cluster that you are adding this server to.
9j Select the IP address that Novell Cluster Services will use for this node.
Some servers have multiple IP addresses. This step lets you choose which IP address
Novell Cluster Services uses.
9k Deselect Start Services Now.
9l Click Next, then continue through the rest of the OES installation.
9m After the install is complete, use the Software Updater (or other update methods) to install
any patches from the OES 2 Linux patch channel and any EVMS patches from the SUSE
Linux Enterprise Server 10 SP2 patch channel.
10 If you have a shared disk system on the cluster, enter
console to verify that the node can see the cluster (SBD) partition on the SAN.
also tells you the device on the SAN where the SBD partition is located.
sbdutil -f
"Assigning Install Rights for Container
Users)" in the OES 2 SP3: Novell Cluster Services
Linux.
sbdutil -f
Converting NetWare 6.5 Clusters to OES 2 Linux
at the Linux terminal
29