Novell OPEN ENTERPRISE SERVER - CONVERSION GUIDE 12-2010 Manual page 31

For detailed instructions, see
Cluster Services 1.8.8 Administration Guide for
5a Log in to the OES 2 Linux server as the
5b In YaST, select Open Enterprise Server > OES Install and Configuration.
5c On the Software Selection page under OES Services, verify that Novell Cluster Services is
selected, then click Accept to continue to the configuration.
Services that you have already installed are indicated by a blue check mark in the status
check box next to the service.
5d On the Software Configuration page, enable Novell Cluster Services configuration, then
click the Novell Cluster Services link.
5e When you are prompted, enter the credentials of the LDAP administrator that is
configured for the server.
5f On the Novell Cluster Services Configuration page, add the server to the existing NetWare
cluster, then click Next.
Parameter
New or Existing Cluster
Cluster FDN
5g On the Proxy User Configuration page, specify one of the following users as the NCS
Proxy user, then click Next.

OES Common Proxy User: If the OES Common Proxy User is enabled in
eDirectory, the Use OES Common Proxy User check box is automatically selected
and the NCS Proxy User Name and Specify NCS Proxy User Password fields are
populated with the credentials of the OES Common Proxy User.

LDAP Admin User: If the OES Common Proxy User is disabled in eDirectory, the
Use OES Common Proxy User check box is automatically deselected and the NCS
Proxy User Name and Specify NCS Proxy User Password fields are populated with
the credentials of the LDAP Admin user. The fields are also automatically populated
with the LDAP Admin credentials if you deselect the Use OES Common Proxy User
check box.

Another Administrator User: Deselect the Use OES Common Proxy User check
box, then specify the credentials of an administrator user.
You can reset the default settings by clicking Back to return to the Novell Cluster Services
Configuration page, then clicking Next to continue again to the Proxy User Configuration
page.
5h On the Configuration page, specify the following parameters, then click Finish.
"Adding a Node to an Existing
Linux.
user.
root
Action
Select Existing Cluster.
Browse to select the Cluster object for the
NetWare cluster, or type the cluster fully
distinguished name.
For example:
cn=nwcluster,ou=clusters,o=mycompany
Converting NetWare 6.5 Clusters to OES 2 Linux
Cluster" in the OES 2 SP3: Novell
31