Sync Engine
Config Engine
You can start and stop Web Admin at any time, as long as the other Synchronizer services are
running.
Each Synchronizer service has its own set of commands:
Section 1.2.1, "Managing the Sync Engine," on page 10
Section 1.2.2, "Managing the Config Engine," on page 10
Section 1.2.3, "Managing the Web Admin Service," on page 10
Section 1.2.4, "Managing the Connector Manager," on page 10
1.2.1 Managing the Sync Engine
Use the following command as
rcdatasync-syncengine status
Use the following commands as
rcdatasync-syncengine start
rcdatasync-syncengine restart
rcdatasync-syncengine stop
1.2.2 Managing the Config Engine
Use the following command as
rcdatasync-configengine status
Use the following commands as
rcdatasync-configengine start
rcdatasync-configengine restart
rcdatasync-configengine stop
1.2.3 Managing the Web Admin Service
Use the following command as
rcdatasync-webadmin status
Use the following commands as
rcdatasync-webadmin start
rcdatasync-webadmin restart
rcdatasync-webadmin stop
1.2.4 Managing the Connector Manager
Use the following command as
rcdatasync-connectors status
10
Novell Data Synchronizer Administration Guide
to check the status of the Sync Engine:
root
to manually start and stop the Sync Engine:
root
to check the status of the Config Engine:
root
to manually start and stop the Config Engine:
root
to check the status of the Web Admin service:
root
to manually start and stop the Web Admin service:
root
to check the status of the Connector Manager:
root