Managing The Synchronizer Services; Managing The Data Synchronizer Services Collectively; Managing The Synchronizer Services Individually - Novell DATA SYNCHRONIZER - ADMINISTRATION GUIDE 07-2010 Administration Manual

Managing the Synchronizer
1
Services
For an overview of the Novell Data Synchronizer services, see:
"Data Synchronizer Product
Installation Guide
"Data Synchronizer Product
The Synchronizer services are managed on the command line in a terminal window.
IMPORTANT: The Synchronizer services must always run as the Linux
Section 1.1, "Managing the Data Synchronizer Services Collectively," on page 9
Section 1.2, "Managing the Synchronizer Services Individually," on page 9
1.1 Managing the Data Synchronizer Services
Collectively
Use the following command as
rcdatasync status
Use the following commands as
rcdatasync start
rcdatasync restart
rcdatasync stop
IMPORTANT: After restarting the Synchronizer services, you must manually restart all connectors
in Synchronizer Web Admin. Always start the GroupWise Connector first before any other
connectors.

1.2 Managing the Synchronizer Services

Individually
If you manage the Synchronizer services individually, they should be started in the following order:
Config Engine
Sync Engine
Connector Manager
The Synchronizer services should be stopped in the following order:
Connector Manager
Overview" in the Novell Data Synchronizer Mobility Pack
Overview" in the Novell Data Synchronizer Installation Guide
to check the status of the Synchronizer services:
root
to manually start and stop all the Synchronizer services:
root
user.
root
Managing the Synchronizer Services
1
9