Adding A User To A Connector Through An Ldap Group; Customizing A User's Synchronization Settings - Novell DATA SYNCHRONIZER - ADMINISTRATION GUIDE 07-2010 Administration Manual

4 Select the user to add to the connector.
5 (Conditional) If the user's username in the application is not the same as the user's network
login, in the Application Username column, click Click to set, then enter the user's application
username in the text box.
Synchronizer uses application usernames to match up users who have different usernames in
various synchronized applications.
6 (Conditional) If you want to apply a user profile to the user, select the profile in the Apply
Profiles drop-down list.
For more information, see
7 Click Add to add the user to the connector.
The user is immediately added to the connector.
8 Add the user to additional connectors to meet the user's data synchronization needs.

4.2.3 Adding a User to a Connector through an LDAP Group

As an alternative to adding users in Synchronizer Web Admin, you can add users to any LDAP
groups that have already been added to a connector. Users who are added to LDAP groups are added
to the Synchronizer system based on the LDAP Group Membership Polling Rate setting, as
described in
page 17.

4.2.4 Customizing a User's Synchronization Settings

By default, all of a user's available address books are synchronized, along with all of the item types
supported for each connector. If necessary, you can limit the amount of data that is synchronized for
a user.
1 In Synchronizer Web
synchronization settings, then click Manage Users.
36 Novell Data Synchronizer Administration Guide
Section 4.1, "Managing User Profiles," on page
Section 3.1.3, "Adjusting the Synchronizer Web Admin Polling Rate for Groups," on
Admin, click the connector where you want to change user
33.