Deleting A User From A Connector - Novell DATA SYNCHRONIZER - ADMINISTRATION GUIDE 07-2010 Administration Manual

2 Click to edit the user's synchronization settings.
The synchronization settings vary depending on the selected connector. They are the same
settings that users see when they access the
connector-specific options, see the Quick Start on the
Documentation Web site (http://www.novell.com/documentation/datasync_connectors1)
the connector where you are editing user settings.
3 Select and deselect options as needed to customize the user's data synchronization, then click
Save.
The user's synchronization settings are immediately changed.

4.2.5 Deleting a User from a Connector

1 (Conditional) If the user was added to the connector as an individual user:
1a In
Synchronizer Web
click Manage Users.
1b In the Manage Users list, click
deletion.
1c Repeat the process for each connector where you want to delete the user.
2 (Conditional) If the user was added to the connector as a member of an LDAP group, delete the
user from the LDAP group in your LDAP directory.
For example, you can use ConsoleOne or iManager to delete the user from the LDAP group in
eDirectory.
The user is removed from the group, and therefore from all connectors where that group is
assigned, according to the group polling rate, as described in
Synchronizer Web Admin Polling Rate for Groups," on page
the polling cycle to pass, you can temporarily set the polling rate to a short period of time or
you can restart the connector.
Data Synchronizer User Options
Admin, click the connector where you want to delete the user, then
for the user to delete, then click Yes to confirm the
page. For
Novell Synchronizer Connectors
Section 3.1.3, "Adjusting the
17. If you do not want to wait for
for
Managing Connectors 37