Program/Random/Relay Play/Power On Play - Denon DN S5000 - DJ Table Top Single CD Player Operating Instructions Manual

ENGLISH

PROGRAM/RANDOM/RELAY PLAY/POWER ON PLAY

15
Program play
• Up to 25 tracks from one disc can be programmed.
• Programs for up to six discs (one program per disc) can be stored in the non-volatile memory for later recall.
NOTE: Such functions as Hot Start, Sampler, Mirror Mix, and Platter Effect do not operate during programmed
playback.
q, e
#3
w, r,
t, y
#2
#1
24
Program mode select
q In the Cue or pause
MEMO
mode, push the PRESET
button for more than 1
PRESET
sec to select preset
mode.
When the PRESET button is pressed at this
time, the program mode is selected.
✽ The mode switches in the following
order each time the PRESET button is
pressed (short press): preset mode →
program mode → random mode → off.
w Turn the
PARAMETERS
1
PUSH
PARAMETERS knob to ON / OFF
select the various
program setting
modes as follows.
Prog.In, Prog.On, Prog.Off,
MemoSet, MemoCall,
Memo Clr
Depending on conditions, some modes
cannot be selected.
MEMO
e Push the PRESET button
again to exit program
mode. PRESET
Input Program (Prog.In)
Input the program for program playback.
r Turn the
PARAMETERS
PUSH
ON / OFF
PARAMETERS knob to
select the track.
t Push the
PARAMETERS
PUSH
2
PARAMETERS knob
-1
ON / OFF
to input the selected
track to the program.
#1 Insert Tracks to Program
• You can insert tracks to the previously
programmed tracks.
• One track can be inserted at a time using
the PITCH BEND + button and return r.
#2 Clear Tracks from Program
• You can clear tracks from the previously
2
programmed tracks.
-2
• One track can be cleared at a time using
the PITCH BEND – button.
y Push the
PARAMETERS
PUSH
PARAMETERS knob
ON / OFF
again to return step
– r.
2-
1
3
• Repeat these steps to input whole
program.
• Push the PRESET button to end the
program input mode, then proceed to
Start Program Play (Prog.On).
Start Program Play (Prog.On)
• When "Prog.On" is selected, DN-S5000 will
cue up at the first track in the program.
• Program playback starts when the 13
4
button is pushed.
#3 You can use program repeat play function
with push EXIT/RELOOP button.
Cancel Program mode (Prog.Off)
• When "Prog.Off" is selected, the program
5
play mode turns off and returns to normal
play mode.
Store Program (MemoSet)
• When "Memo Set" is selected, the program
6
that has been set is stored in the non-volatile
memory.
Call Program (MemoCall)
• When "MemoCall" is selected, the program
7
stored in the non-volatile memory is loaded
and the program play mode is set.
Clear Program (Memo Clr)
• When "Memo Clr" is selected, the program
8
for the loaded disc is cleared.
• To clear all Program Memo use Preset
function.