42
Rear
Wheel
Suspension.
Axle
Shaft
928
DISASSEMBLING
AND
ASSEMBLING
AXLE
SHAF'I
Disassembling
1. Clamp axle shaft in a vise fitted with soft
jaws.
2. Remove clamp and push dust boor with sealing
flange toward inside of axle shaft.
3. Remove circlip.
4. Press off constam velociry
joint using special
tools VW 401 and VW 408 a.
Assembling
1. Seal large diameter
end of new dust boor with
an adhesive.
This requires that seats of sealing
Range and boor be clean and free of grease.
Adhesive:
3 M Scotch Seal 750
(available
in 5 oz. tubes)
2. Squeeze new clamp with a special pliers.
e.g.
VW 1275. between machined
shoulders
of sealing flange.
3. i?ephce gasket on flange cOVel
4. Push dust boor with sealing flange on to shaft.
5. Pack consranr velocity
joint from each side
with approx.
40 grams of special grease uni-
formly.
Total quantity
of grease: 80 grams.
Special grease is only for joint.
Never use
grease in dust cover.
80 grams of special
grease is delivered
with
each spare dust boor and each spare constant
velocity
joint.
42-
24
Disassembling
and Assembling
Axle Shafr
Printed in Germany