Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 266

48
Steering 928
8. Remove suction hose after loosening clamp.
/z;-: -. ;
* -
,' -_
9. Remove bolts on front holder of power steering
pump.
3. Install upper section of drive belt cover
4.
Install suction hose
Install this pressure hose leaving not mope than
25
mm between inner wheel well and hose.
Note:
If hose is routed too close to exhaust manifold, the
hose could come loose from its holder and cause
failure of the power steering.
Asbestos protected hoses are no longer available
for replacements.
Installing 5. Install belt and adjust to remove tension. Also
check tightness of alternator belt (slight correc
tions could be made).
1. Tighten two bolts on front holder: only insert rear
one (belt tightnersl.
6. Bolt on splash shield. Add hydraulic fluid.
Bleed steering system. Check for leaks and
operation.
2. Install pressure hose so that in installed
position the protective ring (arrow) rests on
spring strut mount. IInstalled position:
install drive belt, do not finish installation yet
because of point 3.1
Pressure hoses in initially manufactured cars had
an asbestos sleeve.
Note:
Make sure that no hydraulic fluid is spilled on
alternator belt while disassembling and assembling.
48-8
Removing and Installing Power Steering Pump
Vll. 1963 Printed in Germany
l
a