Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 180

-
a
0
928
Antiblock System
45
1. Coat speed sensor and bore in steering
knuckle with Molykote Longterm 2.
Replace O-ring of speed sensor.
2. Insert speed sensor in steering knuckle
without application of force and tighten
socket head screw to 10 Nm/7 ftlb.
Note:
The distance between speed sensor and pulse
gear is given by design and cannot be
adjusted.
3. Route wires correctly (insert rubber
grommets and clip rubber mount in
holder).
Install exhaust shield.
Connect wire plug and press into holder.
Install front wheel and intake hose.
4. Check operation wrth ABS tester.
Rear Axle
Removing
1. Take off wheel.
2. Turn off ignition, take wire plug out of
holder and unclip wire on rear axle carrier.
3. Disconnect wire plug.
Printed in Germany - V l I I, 1984
Removing and Installing Speed Sensors
45 - 9