Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 300

Steering
48
a
7. Remove steering column switch after disconnecting
plug connector and pulling off plugs, lifting instru-
ment cowl for this.
9. Unlock steering lock and push steering shaft
into steering protective tuba far enough so that
intermediate shaft in engine compartment rests
on camshaft housing.
10. Apply a standard internal-claw puller, e. g.
puller 62 -020 from Schrem in Giengen, in
upper steering shaft bearing. Spread puller
enough so that bearing inner race is not pulled
out of bearing outer race while driving out
bearing (arrow), since otherwise the balls
would fall down into the steering tube.
8. Remove circlip and support on steering shaft.
11. Connect Special Tool VW 771 with internal-
claw puller and drive out upper steering shaft
bearing.
Printed
in Germany
VI. 1982 Replacing Upper Steering Shaft Bearing
48.31