Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 305

48
Steering 926
Dismantling and assembling instructions
Important notes
If the scope of assembly deviates from the fol-
lowing instructions, the safety requirements
for the operation of vehicles with airbag equip-
ment must be observed.
Example: Removing the airbag steering
wheel, working on the contact unit (steering
column switch1 etc.
Safety requirements
Test and assembly operations must only be
carried out by qualified personnel.
Before working on the airbag system or on
adjacent components that entail a risk of live
components getting near the airbag system,
the following safety requirements must be
observed at all times:
1. Switch off ignition.
2. Disconnect and cover negative battery
terminal.
After the battery has been disconnected,
assembly operations or other jobs that require
the use of a hammer or similar tools must
only be performed after a waiting time of
20 minutes has elapsed. This is required to
ensure that the power supply to the airbag
system is interrupted and to make sure the
airbag is not triggered inadvertently.
For further safety requirements, refer to
Repair Group 68.
Adjuster lever positions
Adjusting mechanism of steering wheel height
adjuster closed.
Adjusting mechanism of steering wheel height
adjuster open.
46 - 36
Dismantling and assembling instructions
a
Printed in Germany - XXVII, 19%