Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 29

928
Front Wheel Suspension
40
2.When installing lower control
arm, screw bolts of rear bearing
Close slots for outer cams (page
40 - 23).
clamp into body until only 2
threads are visible.
Do not tighten the two bolts to
specified torque until assembly
is completed and springs have
settled. This keeps front of car
down.
3.To prevent ball pins turning and
to allow installation of collar
nuts (also for disassembly),
apply pressure to upper control
arm to load ball joints.
a
Note:
Spray adjustment
control arm with
threaded section
plate on lower
eccentrics,
of track rod,
upper bearing
._
threaded pins in
joint and threaded pins in lower
bearing joint with Tectyl-UL 846
(Valvoline). This prevents
corrosion of the threaded elements,
thus facilitating maintenance and
repair work.
a
Printed in Germany - XIII, 1986
Disassembling and Assembling
40 - 15
Wheel Suspension (Before and
After Model Year 86)