Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 291

48
Steering
928
11. Pull off plugs on ignition switch. Disconnect
spring for steering wheel height control with a
piece of suitable wire.
12. Remove circlip and support on steering shaft.
Fr"-WY r;/ -7)
\ ,, ,$+-?y
! *y + ,+
&&'i r/ \
i
13. Unscrew mounting bolts on steering tube bracket,
~1
'- "\W :r
-I-c-
?&-w.& /
14. Move up steering tube combined with steering
and intermediate shafts. To prevent seizure of
intermediate shaft on firewall while moving up.
keep to the following procedures. Pull up
steering tube slightly and then push down the
now accessible steering and intermediate shafts
in the steering tube against the stop on the
steering shaft mount. Push down very carefully
to prevent changing sit of mount.
Installing
1. Insert seal in firewall in correct position. Coat
pertinent area and seal with tire assembly paste
to make installation of steering tube easier.
2. Install steering tube with steering and inter-
mediate shafts in car.
Preparations:
Circlip and support of steering shaft removed,
steering shaft pushed down in steering tube,
intermediate shaft pushed through firewall.
Slide up steering shaft again before moving
steering tube into firewall. Install support and
steering wheel mounting nut temporarily
instead of the circlip.
a
48-22
Repairing Steering and Intermediate Shafts
with Steering Tube
Printed in Germany