Porsche 928 - WORKSHOP MANUAL 1977 Workshop Manual page 208

928
Brakes/Mechanical Parts
CHECKING SETTING OF STOPLAMP SWITCH
In 1984 models onward, a
mechanically operated switch
mounted on a bracket above the
brake-pedal arm is installed as
stoplamp switch.
With the pedal arm against its stop
(initial position), there must be a
5 mm gap between stoplamp switch
and brake-pedal arm. If necessary,
adjust position of stoplamp switch
by turning mounting nut until the
gap is as specified. Turn nuts in
opposite directions (counter).
Printed in Germany -
XIII, 1986
Checking Stoplamp Switch
46
- 10a
Setting