Panic Errors - Dell PowerVault 50F Installation And Troubleshooting Manual

" 
* 
FREETIMRLSD (0)
INCONSISTENT (0)
MALLOC (0)
MSGQCREATE (0)
MSGQDELETE (0)
SEMCREATE (0)
SEMDELETE (0)
TASKSPAWN (0)
TIMEUSECNT (0)
ZOMTIMKILL (0)
ZOMTIMSET (0)
support.dell.com
This module includes errors that cause a system panic to occur. A system panic
causes the switch to reboot. The error is stored in flash memory with a stack trace,
local stack content and local register content at the time the error occurred.
To view the trace, allow the switch to reboot and issue the traceShow command. If
the trace was caused by an error, the first line displays:
Panic errors have the highest severity (0).
NOTE: Use the traceShow command to identify panic errors as the errShow com-
mand is not useful in this case.
Panic errors are described in Table A-2.
"  
A task freed an already free timer.
An internal inconsistency has been
detected.
The switch has run out of memory.
A message queue could not be
created.
A message queue could not be
destroyed.
A semaphore could not be created.
A semaphore could not be
destroyed.
A task could not be created.
A timer was not released after
expiration.
An attempt was made to kill a timer
that was in 'zombie' state.
An attempt was made to set a timer
that was in 'zombie' state.
)  
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Issue the traceShow command. Contact
customer support.
Error Messages A-5