Removing The Power Supply; Installing The Power Supply; Removing A Gbic Module; Installing A Gbic Module - Dell PowerVault 50F Installation And Troubleshooting Manual
Dell powervault 56f 16-port fibre channel switch installation and troubleshooting guide
Hide thumbs
Also See for PowerVault 50F:
- Installation and troubleshooting manual (156 pages) ,
- User manual (42 pages) ,
- Rack installation manual (28 pages)
Table of Contents
Advertisement
support.dell.com
1.
Remove all external cabling from the front panel.
2.
Remove the power supplies.
See "Removing the Power Supply," found earlier in this chapter for instructions.
3.
Remove all GBICs.
See "Removing a GBIC Module," found earlier in this chapter for instructions.
4.
Remove the system board.
See "Removing the System Board" found earlier in this chapter for instructions.
5.
Remove the fan tray assembly.
See "Removing the Fan Assembly," found earlier in this chapter for instructions.
1.
Install the system board.
See "Installing a System Board," found earlier in this chapter for instructions.
2.
Install the fan tray assembly.
See "Installing a New Fan Assembly," found earlier in this chapter for instructions.
3.
Replace the switch's cover.
4.
Reinstall the GBICs.
See "Installing a GBIC Module," found earlier in this chapter for instructions.
5.
Install the power supply(s).
See "Installing the Power Supply," found earlier in this chapter for instructions.
6.
Turn on the switch's power.
The switch automatically runs POST .
7 .
Check for error messages by issuing the Telnet command.
Repair and Replacement
6-7
Advertisement
Table of Contents
