Dell PowerVault 50F Installation And Troubleshooting Manual page 139


" 
 * 
INPORT (2)
MSG (2)
REMDOMAIN
(2)
SCN (3)
VERSION (2)
HLO INVHLO (1)
LSDB LSID (2)
MCAST ADDBRANCH
(2)
ADDPORT (3)
NOPARENT (2)
NOPARENTLS
R (2)
support.dell.com
"  
The input port in the IU received
by the path selection task is out
of range.
The path selection task has
received an unknown message
from another task.
The message received from a
neighbor switch has a source
domain ID out of range.
The path selection task has
received a State Change Notifica-
tion message that it does not
recognize.
The FSPF protocol version run-
ning on the local switch is lower
than a neighbor's switch.
The path selection task has
received a HELLO message with
an invalid parameter from a
neighbor switch.
A Link State Record received as
part of a Link State Update has
an out of range domain ID.
A branch is being added to a
broadcast or multicast tree, but
the parameters are incorrect.
A multicast routing table pro-
gramming failed.
An error occurred while comput-
ing a broadcast or multicast tree.
An error occurred while comput-
ing a broadcast or multicast tree.
)  
Check that all paths and routing tables are
correct. If they are not correct, reboot the
local switch.
Check that all paths and routing tables are
correct. If they are not, reboot the neigh-
bor switch.
Check the paths and routes again. If they
are still incorrect, reboot the local switch.
Check that all paths and routing tables are
correct. If they are not, reboot the neigh-
bor switch.
Check the paths and routes again. If they
are still incorrect, reboot the local switch.
Check that all paths and routing tables are
correct. If they are not, reboot the local
switch.
Check the protocol version on both
switches using the fspfShow command.
If the two versions differ, update the soft-
ware on the local switch.
Check that all paths and routing tables are
correct. If they are not, reboot the neigh-
bor switch.
Check the paths and routes again. If they
are still incorrect, reboot the local switch.
Check that all paths are correct. If any
path is missing to any switch in any part of
the fabric, reboot the switch with the
missing path.
If this is caused by a configuration
command, check the parameter values.
Otherwise, check the broadcast tree with
the bcastShow command. If the tree is
incorrect, reboot the local switch.
Run the portLogShow command. Con-
tact Customer Support.
Run the LSDbAllShow command. Con-
tact Customer Support.
Run the LSDbAllShow command. Con-
tact Customer Support.
Error Messages A-3