Dell PowerVault 50F Installation And Troubleshooting Manual page 140


" 
 * 
REMPORT (3)
SPFCOST (3)
NBFSM NGBRSTATE
(2)
UCAST ADDPATH (1)
RELICPDB (2)
SPFCOST(3)
MQ QREAD (1)
QWRITE (1)
SYS NOMEM (1)
SYSCALL (2)
TIMERS ENQFAIL (1)
MSG (3)
A-4 Installation and Troubleshooting Guide
"  
Removing an entry from a multi-
cast routing table failed.
An error occurred with comput-
ing the multicast path tree.
An error occurred in the neighbor
Finite State.
A static path configuration failed.
The path selection task received
an E_Port SCN, but the port was
already ISL.
An error occurred with comput-
ing the unicast path tree.
A task was unable to receive a
message.
A task was not able to post a
message on a queue.
The system's memory is
exhausted.
A system call into VxWorks
failed.
An error occurred while setting a
timer.
The timer task received an
unknown message.
)  
Run the portLogShow command. Con-
tact Customer Support.
Run the LSDbAllShow command. Con-
tact Customer Support.
Check the neighbor's state with the
nbrStateShow command.
If the state is not NB_ST_FULL, force a
state change with the portDisable com-
mand followed by portEnable.
After a few seconds, if the state is not
NB_ST_FULL, reboot both the local and
remote switches.
Check command parameters.
Run the ucastAllShow command. Con-
tact customer support.
Run the LSDAllShow command. Contact
customer support.
Run the command show <queue ID>
with the ID of the queue reported in the
error. Contact customer support.
See "MQ-QWRITE Error" found later in
this chapter for more information.
Reboot the switch. Contact customer
support.
Reboot the switch. Contact customer
support.
Reboot the switch. Run the commands
actTimersShow and timerShow
<timer ID>. Contact customer support.
Contact customer support.