Dell PowerVault 50F Installation And Troubleshooting Manual page 82

Dell powervault 56f 16-port fibre channel switch installation and troubleshooting guide
Hide thumbs Also See for PowerVault 50F:
Table of Contents

Advertisement

4-26 Installation and Troubleshooting Guide
% 
   
stat_wtx
Number of 4-byte words transmitted from the port
stat_wrx
Number of 4-byte words received by the port
stat_ftx
Number of frames transmitted from the port
stat_frx
Number of frames received by the port
stat_c2_frx
Number of Class 2 frames received
stat_c3_frx
Number of Class 3 frames received
stat_lc_rx
Number of link control frames received
stat_mc_rx
Number of multicast frames received
stat_mc_to
Number of timeouts reported for multicast frames; a single
frame could cause this counter to increment if it timed out for
each multiple destination
stat_mc_tx
Number of multicast frames transmitted
tim_rdy_pri
Amount of time (measured in proprietary ticks) that R_RDY
transmission has higher priority than frame transmission
tim_txcrd_z
Time that this port cannot transmit frames due to a transmit
buffer-to-buffer credit of zero
er_enc_in
Received data: the number of 8b/10b encoding errors that have
occurred inside frame boundaries; this counter is generally a
nonzero value, although occasional errors may occur on a normal
link and give a zero result; (Minimum compliance with the link bit
error rate specification on a link continuously receiving frames
would cause approximately one error every 20 minutes.)
er_crc
Received frames: the number of CRC errors detected
er_trunc
Received frames: the number of frames that were shorter than
the minimum Fibre Channel frame size (for example, a header
with no payload)
er_toolong
Received frames: the number of frames that were longer than
the maximum Fibre Channel frame size (for example, a header
with a 2,112-byte payload)
er_bad_eof
The number of frames received with a badly formed end-of-
frame
er_enc_out
Receive link: the number of 8b/10b encoding errors recorded
outside frame boundaries; this number may become nonzero
during link initialization but indicates a problem if it increments
faster than the allowed link-bit error rate (approximately once
every 20 minutes)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powervault 51fPowervault 56f

Table of Contents