Syslogdip; Tempshow - Dell PowerVault 50F Installation And Troubleshooting Manual

support.dell.com
%    
Port state The port state follows the GBIC type; the possible port states
include:
Comment field The comment field follows the port state. The possible com-
ments include:
The syslogdIp command sets or displays the switches system log daemon IP
address. The command syntax is syslogdip <ip address>.
The following example shows the tempShow command screen, which shows the
switch's temperature as measured by five sensors on the system board.
No_Card — No card present in this switch slot
No_Module — No GBIC module in this port
No_Light — The module is not receiving light
No_Sync — The module is receiving light but is out of
sync
In_Sync — The module is receiving light and is in sync
Laser_Flt — The module is signaling a laser fault (defec-
tive GBIC)
Port_Flt — The port has been marked faulty (defective
GBIC, cable, or device)
Diag_Flt — The port failed diagnostics (defective G_Port
or FL_Port card or system board)
Online — The port is up and running
Lock_Ref — The port locking to the reference signal
Testing — Running diagnostics
—
Disabled The port is disabled
—
Loopback The port is in loopback mode
—
E_Port The WWN and switch name of the other
switch is shown, the use of this Inter Switch Link (ISL) is
shown (see FC_SW)
—
F_Port The WWN of the N_Port is shown
—
G_Port The port is online but is not yet an E_Port or
F_Port
—
L_Port The port is connected to an arbitrated loop
PowerVault 56F 16-Port Fibre Channel Switch Commands 4-31