Compaq ProLiant 1600 Administrator's Manual page 163

Table B-1
Informational Messages
Message
The loop has been locked by
another application.
This RA4000 is in
Active/Standby mode. All the
Logical disks in this Array must
have same path assignments.
Are you sure you want to
continue?
You have not selected all the
Paths to the following logical
disk(s):
You have not selected an Active
Path to <xxxxxx>.
You have not selected any Paths
to <xxxxxx>.
You have not selected a Standby
Path to <xxxxxx>.
Using Compaq Redundancy Manager in a Single-Server Environment B-11
continued
Description
This message indicates that
another application has issued a
lock management command to
an array controller. The lock
management command only
allows you to view the data.
This message indicates that you
have made a request to change
the status of a path in an
Active/Standby configuration.
This message indicates that the
logical disk or drives shown are
claimed but you did not assign
all possible paths.
This message indicates that you
claimed a logical disk but did
not select an Active Path.
This message indicates that you
claimed a logical disk but did
not assign any paths.
This message indicates that you
claimed a logical disk but did
not select a Standby path.
Action
No action needed to view the
data.
Proceed or click Cancel.
Click OK for the Redundancy
Manager to automatically assign
the paths for this logical disk;
Or, click Cancel to assign the
paths yourself.
Click OK for the Redundancy
Manager to automatically assign
the path for this logical disk;
Or, click Cancel to assign the
path yourself.
Click OK for the Redundancy
Manager to automatically assign
the paths for this logical disk;
Or, click Cancel to assign the
paths yourself.
Click OK for the Redundancy
Manager to automatically assign
the path for this logical disk;
Or, click Cancel to assign the
path yourself.