Compaq ProLiant 1600 Administrator's Manual page 146

Table 6-8
Error Messages
continued
Message
Logical disk could not be
reached in the following
RA4000: <xxxxxx>.
The lock could not be set.
The loop has been locked by
another application. Redundancy
Manager is running in Read Only
mode.
There was an error attempting
to shut down Windows NT.
Please close all applications and
shut down now.
A version of the Compaq Fibre
Channel Host Adapter SCSI
Miniport Driver (cpqfcalm.sys) is
being used that does not
support redundancy. The
minimum version for
redundancy support is VX.X. The
current version is VX.Z.
Redundancy has been disabled.
Troubleshooting the Compaq ProLiant Clusters HA/F100 and HA/F200 6-21
Description
Redundancy Manager found an
array with no drives in it. This
could be caused by a damaged
array or a bad connection.
The array controller board is in
an unknown state that caused a
failed connection to the array
controller.
Another application has issued a
lock management command to
an array controller. The lock
management command only
allows viewing the data.
An error occurred while shutting
down Windows NT.
This message informs you that
the version of cpqfcalm.sys
doesn't support redundancy.
Action
Check the array and all
connections.
No action needed to view the
data.
To configure the data, check the
array controller and all physical
connections.
No action needed to view the
data.
To configure the data, close the
other application to unlock the
array controller. If the lock has
expired, Redundancy Manager
allows overriding the lock and
taking control of the array
controller.
Close all applications and shut
down the computer
immediately.
Make sure you have the correct
version of cpqfcalm.sys.