Compaq ProLiant 1600 Administrator's Manual page 90

Setting Up the Compaq ProLiant Clusters HA/F100 and HA/F200 3-17
IMPORTANT: Node2 Exception: Repeat SmartStart Assisted Integration steps 1-11 for
Node2. Then proceed to step 17.
IMPORTANT: Node1 Exception: Execute step 18 only after Node2 is set up.
18. Run the Compaq Cluster Verification Utility (CCVU) on both nodes to
ensure that your system is ready for cluster installation.
Use the Compaq Cluster Verification Utility CD in your cluster kit to
install the Compaq Cluster Verification Utility, then follow the steps
listed below.
To automatically install CCVU, insert the Compaq Cluster Verification
Utility CD in the CD-ROM drive. Installation should automatically run.
If manual installation is necessary:
a. Select Start, Run.
b. Click Browse and select the CD-ROM drive.
c. Double-click SETUP.EXE.
Follow these steps to run the Compaq Cluster Verification Utility:
a. On the Microsoft Windows NT desktop, select Start, Programs,
Compaq Utilities, Compaq Cluster Verification Utility.
b. Select a Test by highlighting the cluster model you are verifying.
c. Click Next.
d. Select one or two computers on which to perform the verification
tests.
e. Click Add to add a computer to the selected list.
f. Click Finish. You must have at least one computer on the selected
list before clicking Finish.
NOTE: You must have administrative accounts with identical username and password on
the computers selected.
g. Click Remove to remove a computer from the selected list.
For more information about CCVU, refer to the online documentation
(CCVU.HLP) included on the CD.