Compaq ProLiant 1600 Administrator's Manual page 88

Setting Up the Compaq ProLiant Clusters HA/F100 and HA/F200 3-15
6. After you have completed using the Array Configuration Utility, the
system will reboot and SmartStart will automatically create your system
partition.
7. Next, you will be guided through steps to install addition Compaq
software and utilities including choosing the NT boot partition size and
installing the Compaq Support Software Disk (SSD). Follow the
instructions in the SmartStart setup poster.
IMPORTANT: Node2 Exception: When configuring Node2, exit out of the Diskette Builder
Utility and go to step 9.
8. After the Diskette Builder Utility has loaded, create the Options
ROMPaq utility in Diskette Builder. Label the diskettes you create. The
Options ROMPaq utility updates the firmware on the array controllers
and the hard drives. For more information about Options ROMPaq, refer
to the Compaq StorageWorks RAID Array 4000 User Guide. You can
also create the SSD during this process.
9. At this time, the system will reboot to prepare for the operating system
installation. When prompted, insert the Windows NT
Server 4.0/Enterprise Edition (Retail) or Windows NT
Server 4.0/Enterprise Edition (Select) CD.
10. When prompted, install Service Pack 3. After Service Pack 3 is
installed, the server reboots and Enterprise Edition Installer loads
automatically.
11. Exit the Enterprise Edition Installer.
IMPORTANT: Node2 Exception: Open Disk Administrator and when prompted for drive
signature stamp, choose yes. After this process is complete, exit Disk Administrator.
12. Open Disk Administrator and create disk partitions.
13. Power down the server, insert Options ROMPaq diskette in Node1, and
restart the system.
IMPORTANT: When updating the firmware on the array controllers, make sure that
Node2 is powered off.
IMPORTANT: Node2 Exception: Do not update the firmware on the array controllers when
setting up Node 2. Skip to step 17.
14. Run Options ROMPaq from diskettes and choose to update the firmware
on the array controllers.
15. After firmware update completes, power down the storage and server.