Sntp Servers - Linksys MGBLH1 - Gigabit LH Mini-GBIC SFP Transceiver User Manual

Using the web-based Utility for Configuration
Setup Tab - Time
Daylight Savings—Select Daylight Savings to enable it on the switch. If the switch should
use US daylight savings, then select USA. If the switch should use EU daylight savings, then
select European. If it should use another kind of daylight savings, then select Custom and
complete the From and To fields.
Time Set Offset— For European or Custom daylight savings, specify the time change in
minutes. The default is 60 minutes. You may enter 1-1440 minutes.
From—If you selected Custom for the Daylight Saving setting, then enter the date and time
when daylight savings begins.
To—If you selected Custom for the Daylight Saving setting, then enter the date and time when
daylight savings ends.
Recurring—If you selected Custom for the Daylight Saving setting and daylight savings has the
same start and end dates and times every year, then select Recurring.
From—If you selected Recurring, then enter the date and time when daylight savings begins.
To—If you selected Recurring, then enter the date and time when daylight savings ends.

SNTP Servers

Server1—Enter the the IP address of the primary SNTP server here.
Server2—Enter the IP address of a secondary SNTP server here.
SNTP Polling Interval—The maximum number of seconds that the switch waits before polling
the SNTP server. The default interval is every 1024 seconds (approximately 17 minutes). You
may enter 60-86400 seconds.
Click the Save Settings button to save your changes or click Cancel Changes to discard the
information.
SRW2024P User Guide 34