Poe Configuration - Linksys MGBLH1 - Gigabit LH Mini-GBIC SFP Transceiver User Manual

Select Edit and press the Enter key to make changes. When your changes are complete, press
the Esc key to return to the Action menu. Select Save and press the Enter key to save your
changes. To exit, select Quit and press the Enter key.
You can use the Port Configuration screen to enable or disable an interface, set auto-
negotiation and the interface capabilities to advertise or manually fix the speed, duplex mode,
and flow control.
Enable—Allows you to manually enable or disable an interface. You can disable an interface
due to abnormal behavior (for example, excessive collisions), and then enable it again, once the
problem has been resolved. You may also disable an interface for security reasons.
Auto-negotiation (Port Capabilities)—Allows auto-negotiation to be enabled/disabled. When
auto-negotiation is enabled, you need to specify the capabilities to be advertised. When auto-
negotiation is disabled, you can force the settings for speed, mode, and flow control. The
following capabilities are supported:
• 10half – Supports 10 Mbps half-duplex operation
• 10full – Supports 10 Mbps full-duplex operation
• 100half – Supports 100 Mbps half-duplex operation
• 100full – Supports 100 Mbps full-duplex operation
• 1000full – Supports 1000 Mbps full-duplex operation
(Default: Auto-negotiation enabled; Advertised capabilities for 100Base-TX – 10half,
10full, 100half, 100full; 1000Base-T – 10half, 10full, 100half, 100full, 1000full; 1000Base-
SX/LX/LH (SFP) – 1000full; 100Base-FX (SFP) – 100full
Speed/Duplex—Allows manual selection of port speed and duplex mode (that is, with auto-
negotiation disabled).
Flow Control—Allows automatic or manual selection of flow control.

PoE Configuration

On the Switch Main Menu screen, select PoE Configuration and press the Enter key if you want
to configure the switch's ports.
SRW2024P User Guide
Using the Console Interface for Configuration
Configuring the Switch through the Console Interface
24