Denon AVR-985 Operating Instructions Manual page 63

After starting playback
[1] Adjusting the sound quality (TONE)
The tone control function will not work in the PURE DIRECT and the
DIRECT mode.
The tone switches as follows each time
1
the TONE CONTROL button is pressed.
BASS
(Main unit)
2 With the name of the volume to be
SELECT
adjusted selected, turn the SELECT knob
to adjust the level.
(Main unit)
• To increase the bass or treble: Turn the control clockwise.
(The bass or treble sound can be increased to up to +6 dB
in steps of 1 dB.)
• To decrease the bass or treble: Turn the control clockwise.
(The bass or treble sound can be decreased to up to –6 dB
in steps of 1 dB.)
[2] Listening over headphone
1 Plug the headphone' plug into the
jack.
Connect the headphone to the
PHONES jack.
The pre-out output (including the
speaker output) is automatically
turned off when headphone are
connected.
[3] Turning the sound off temporarily (MUTING)
1 Use this to mute the audio output
temporarily.
Press the MUTING button.
(Remote control unit)
[4] Combining the currently playing sound with the desired image
1 Simulcast playback
Use this switch to monitor a video source other than the audio
source.
Press the VIDEO SELECT button, turn the FUNCTION knob
until the desired source appears on the display.
VIDEO
SELECT
(Main unit)
Cancelling simulcast playback.
• Select "SOURCE" using the VIDEO SELECT button and
the FUNCTION button.
• Switch the program source to the component connected
to the video input.
• Press the SOURCE button.
TREBLE
PHONES
Cancelling MUTING mode.
Press the MUTING button again.
FUNCTION
(Main unit)
3
(Main unit)
1
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphone.
1 1 1
If you do not want the bass and treble to
be adjusted, turn on the tone defeat
mode.
The signals do not pass through the
bass and treble adjustment circuits,
providing higher quality sound.
1
1
F U N C T I O N
V I D E O S O U R C E
2 3 1
1
63