Denon AVR-985 Operating Instructions Manual page 11

Connecting the MULTI ZONE jacks
For instructions on operations using the MULTI ZONE FUNCTIONS. (See page 65 ~ 67)
[1] ZONE 2 preout CONNECTIONS
• If another power amplifier or pre-main (integrated) amplifier or is connected, the ZONE2 preout (variable/fixed level) jacks can be used to play a
different program source in ZONE2 the same time. (See page 67)
• The ZONE2 video out is only for the ZONE2.
[2] ZONE2 SPEAKER OUT and PREOUT CONNECTIONS
• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 output terminals can be used to play a different program
source in ZONE2 the same time.
• ZONE2 SPEAKER OUT can be used when "ZONE2" is selected at System Setup Menu "Power Amp Assign". In this case , Surround Back
Speaker OUT cannot be used for MAIN ZONE. (See page 43)
ZONE2
Integrated pre-main amplifier
RC-617INFRARED
or power amplifier
SENSOR
B
Extension jacks for future use.
CONTROL terminal
Perform the following operation before using an external controller connected to the RS--232C terminal:
1. Press the ON/STANDBY button on the main unit and set the unit to the operating mode.
2. Perform the operation to turn off the power from the external control.
3. Check that the product has been set to the standby mode.
After checking the above, check the connections of the external controller. Operation is possible.
ZONE2
Integrated pre-main amplifier
or power amplifier
B
Extension jacks for future use.
RC-616
INFRARED
RETRANSMITTER
OUTPUT INPUT
+ +
L
R
RC-616
INFRARED
RETRANSMITTER
RC-617 INFRARED
SENSOR
OUTPUT INPUT
+ +
L
R
NOTE:
• The settings must
be changed to use
this speaker for
ZONE2.
(See page 43.)
( L )
SURROUND BACK/ZONE2 SPEAKER SYSTEMS
AUX OUT
AUX OUT
( R )
11