Denon AVR-985 Operating Instructions Manual page 35

2-5 Setting the low frequency distribution
This screen is not displayed when not using a subwoofer and all speakers are set to small size .
• Set the subwoofer mode according to the speaker system being used.
1
(Remote control unit)
2
(Remote control unit)
3
(Remote control unit)
4
(Remote control unit)
NOTES:
— Assignment of low frequency signal range (2-1) —
• The only signals produced from the subwoofer channel are LFE signals (during playback of Dolby Digital or DTS signals) and the low
frequency signal range of channels set to "SMALL" in the setup menu. The low frequency signal range of channels set to "LARGE" are
produced from those channels.
— Crossover Frequency (2-4) —
• When "Subwoofer" is set to "Yes" at the "Speaker Configuration Setting", set the frequency (Hz) below which the bass sound of the
various speakers is to be output from the subwoofer (the crossover frequency).
• For speakers set to "Small", sound with a frequency below the crossover frequency is cut, and the cut bass sound is output from the
subwoofer instead.
(• When the subwoofer set to "NO", the bass sound is output from the speaker set as "Large".)
NOTE: For ordinary speaker systems, we recommend setting the crossover frequency to 80 Hz. When using small speakers, however,
setting the crossover frequency to a high frequency may improve frequency response for frequencies near the crossover frequency.
— Subwoofer mode (2-5) —
• The subwoofer mode setting is only valid when "LARGE" is set for the front speakers and "YES" is set for the subwoofer in the "Setting
the type of speakers". (see page 30).
• When the "LFE+MAIN" playback mode is selected, the low frequency signal range of channels set to "LARGE" are produced
simultaneously from those channels and the subwoofer channel.
In this playback mode, the low frequency range expand more uniformly through the room, but depending on the size and shape of the room,
interference may result in a decrease of the actual volume of the low frequency range.
• Selection of the "LFE " play mode will play the low frequency signal range of the channel selected with "LARGE" from that channel only.
Therefore, the low frequency signal range that are played from the subwoofer channel are only the low frequency signal range of LFE (only
during Dolby Digital or DTS signal playback) and the channel specified as "SMALL" in the setup menu.
• Select the play mode that provides bass reproduction with quantity.
• When the subwoofer is set to "Yes", bass sound is output from the subwoofer regardless of the subwoofer mode setting in surround modes
other than Dolby/DTS.
• In surround modes other than Dolby Digital and DTS, if the subwoofer is set to "YES", the low frequency portion is always output to the
subwoofer channel. For details, refer to "Surround Modes and Parameters". (See page 68)
Select the "Subwoofer Mode Setup" at the Speaker Setup
Menu.
Display the Subwoofer mode screen.
Select the setting.
Enter the setting.
The Speaker Setup Menu reappears.
35