Denon AVR-985 Operating Instructions Manual page 28

1-5 Setting the MIC Input Select
• Use this setting when using a microphone other than the included one for measurements when performing the auto setup procedure.
• The microphone included with the AVR-2805 is a measurement microphone designed specifically for use during the auto setup procedure.
Select "Mic" and connect the included microphone to the "SETUP MIC" mini-jack. When conducting the auto setup procedure using a separate
high performance condenser microphone for measurements, select "V.AUX L" and connect the microphone to the "V.AUX Lch" pin jack.
Please ask the DENON Authorized Service Center about the usable microphone other than the option setup.
1
(Remote control unit)
2
(Remote control unit)
3
(Remote control unit)
4
(Remote control unit)
1-6 Check the EQ parameter
• The frequency characteristic of each speaker is rectified and the tone of the speaker is unified.
The EQ parameters that were set in Auto Setup can be checked.
This item is automatically displayed, after the measurement result of the "Auto Setup / Room EQ" is decided.
1
(Remote control unit)
2
(Remote control unit)
28
Select "Mic Input Select" at the Auto Setup / Room EQ Menu.
Display the Mic Input Select screen.
Select the Mic input jack or V.AUX L jack.
Enter the setting.
The Auto Setup / Room EQ Menu reappears.
Select "EQ Parameter Check" at the Auto Setup / Room EQ
Menu.
Display the EQ Parameter Check screen.